General Category > ASL Scripts
Boolean operation problem!
Bugtrooper:
It not worked.... maybe I doing something wrong...
Bugtrooper:
If I post the project can anyone help?
RudySchneider:
It couldn't hurt...
Bugtrooper:
http://www.megaupload.com/?d=GBTBWV33
Here is it!
kreator:
This operation will not work, as you are trying to do a union to a curved surface.
To complete the operation You need a flat surface do the union, then do a bend modifier to that, to get your curve.
I think it pays to pre-think the model before getting too far into it, this model just needed one section to be worked on to get it how you wanted, then you could have duplicated and attached each section.
If you don`t want to re-start, I`d just add half spheres at intervals then do a "Join Solids"
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version