Artwork > Finished Works and Works in Progress

RAH-66 Comanche

<< < (2/3) > >>

rellik420:
u could try making a copy or 2 of your rotor then make it more transparent and stick it in between your blades. i dont know how fast u can get that thing spinning but i think if u try that it might get the illusion ur looking for.

floyd86:
Nice model. Is this from some tutorial? It looks familiar....
The motion blur could be done with some compositing in After effects or some similar program. But If you want to do it in anim8or you can try the methods of sgwan and rellik. Take a good look at a real chopper first and think how you can recreate this in anim8or.

ADSohr:
thanks for the tips.

floyd: no, this is an entirely original model based on a real world helicopter. used alot of reference images to get the shape right.

here is a picture of the interior

floyd86:
Maybe it was a tutorial of a similar type of chopper ;)

ADSohr:
Kreator: thanks for the link, i had thought that it would be possible to use transmaps and visibility to slowly blur the rotors as it gets up to speed. looking at this particular chopper in flight shows that the rotor makes less blur when at speed than say a 2 bladed prop, which has less visible lines due to the much higher RPMs than a rotor with more blades. in order to make a more defined blur i could render an image of the modeled rotor, and make a few slightly rotated transmaps and then layer them together to make a blur. this could give a bit of depth to the blur when viewed from the edge as well, and a few morphs can give the effects seen by increasing the cyclic(rotating the rotors to give more lift).

Floyd89: i have not seen any tutorials on making a helicopter but maybe i should look for it. might offer a little assistance

Navigation

[0] Message Index

[#] Next page

[*] Previous page