General Category > General Anim8or Forum

Meshing

(1/1)

spicy:
I have an anim8or project that i am working on. I converted it to mesh, it was fine. Then back to sundivided, then when I went back to mesh it doesn't do it normally. i have to go into wireframe view (Manually) to see the points. Plus I can't see any other points when in subdivided, in point edit mode, line select or the other one (Can't remember). Can anyone help me? There is something wrong

RudySchneider:
You can't simply "flip" from subdivided back to mesh.  To manually un-do a subdivision, double click on your subdivided object, which should open the Subdivision Editor dialog box.  Enter 0 and 1 in the "Working" and "Final" Divisions cells, and click OK.  This will take the object back to a non-subdivided state, and you can manipulate it to a mesh as necessary.

Navigation

[0] Message Index