Artwork > Anim8or Challenges
[ COMPLETE ] Challenge #14: Sports equipment
$imon:
3D Joe; Thanks! Appreciate it a lot :)
Hiho; In the attached image you can see a setup of the render, the ceiling lights were fully emissive squares to reflect the lights, but to produce a shadow i had to make 8 lights with soft shadows on the complete surface to simulate a square lightsource. Do that times 6 for all the ceiling lights. Then I added the window planes and lights for that, and reflective lights off the walls from a 'sun' shining in the locker room. Add a few environmental lights to that and we get to 66 ;)
It wasnt too bad on me or the renderer, I copied quite a few lights in the source of the .an8 files so I didnt have to make them all myself. The render only took 7 hours so my computer is still alive haha
rellik420:
$imon you are the king of realism. great job.
and for johnar. i think you should model the top (frilly part) of the birdy ( or shuddle cock (depends on where your from)). then transmap the bulk of it. im not that good at texturing but i think that might b the best way to do it.
kuba, i dont think any of us really know what a bobsled is exactly sposed to look like so i think your safe if you miss some key points to it. "one for the money, two for the show, three to get ready, go go go" -cool runnings. (i think thats what they say)
3Dgeek11:
Three words: That is awesome.
Beautiful render, $imon! I'll definitely enter now, to try to beat you. =P J/k I couldn't beat that right now. But I will still try to enter. I'm still pondering what to model.. ::)
johnar:
Heres mine. I modelled the frilly bits on the flying thingys. :)
I can't work out the transmaps from the manual. ???
But am quite glad i modelled them in the end.
This'll probly be my final. ;D
davdud101:
I might just drop out. I can't think of anything.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version