General Category > Anim8or v0.98 Discussion Forum
Feature Request Thread
Steve:
Sluggs
--- Quote from: Sluggs on February 02, 2016, 02:32:03 am ---I'd really like to be able to lock the knife tools (like I can with the add edge tool), so I can only cut in one direction. :-)
--- End quote ---
Ooops! I missed that. Wait for the next build, then just disable the X- or Y-axis :)
Sluggs:
;D
That's awesome, thank you!
Sluggs:
Steve, any chance you could also make it so we can gridsnap a spline's/knot's control point(s)? It would be very useful! :-) (This is a nice feature of Inkscape and it would be awesome if Anim8or could do this too!)
Steve:
Sluggs: Build 1219 supports x/y axis limits for the Knife Cut tool. Splines points already supported it. Are you referring to the two ends of the control handles instead? They aren't snapped because the effect on the spline is non-linear so I'm nit sure how this could be useful. But if it is I'll add it.
Sluggs:
I'm already using it and it works great, and is very useful, thank you! :-)
Yes, I was referring to the two points on the ends of the control handles. If we could gridsnap those, we would have even more control of a spline segment. (I've attached an image to try and show you what I mean) :-)
If I was to position those without gridsnapping them, that curve wouldn't be perfect. Hope that helps. :-)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version