General Category > Ongoing Anim8or Development
Changed to Older Releases [builds 1162 to 1230]
captaindrewi:
Using arc rotate fixes it ,as does changing view to ortho or perspective.
No luck resizing the window or typing the F keys.
Steve:
OK I found the problem. It's not with your graphics card. When the "Show Scale" option is enabled (see the Options->Grid... dialog) the figure is smashed into the lower left-hand corner but only in the Front, Back, Top, Bottom, Left and Right views, which incidentally are the ones that show the numbers.
I'll have a fix up shortly.
Thanks, everyone, for all the test reports!
Steve:
OK give build 1179 a try.
- Fix #098-068 - When Grid Scale is shown Figures collapses into the lower left corner.
Trevor:
Love the new grid numbers.
I have a couple of things though...
In CAD mode, what was the use for the black arrow on the left of the screen? it doesnt seem to do anything when placing objects or rotating objects.
Cylinders used to oriantate with mouse drag when creating them. Now they always point upward. Is this supposed to happen?
Trev
Steve:
The black arrow in CAD mode is used for alignment. If you click on it it turns yellow and then when you move an object it's bottom, top and center will snap to the yellow line.
You can drag the arrow up and down and if grid lock is on it snaps to the grid settings. You can also double click along the bottom of the window to switch it to a vertical tool.
However, it appears that I have broken it sometime during all the changes I've been making, so it snaps to arbitrary values :(
I changed cylinders to stay upright so they will be more like the other shapes, also so you can set both the height and diameter instead of making them a constant ratio.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version