General Category > Ongoing Anim8or Development
Changed to Older Releases [builds 1162 to 1230]
Steve:
fromsoysauce: After you select the edges click-drag directly on one of the selected edges to extrude them. If you click on something else they are deselected. This is slightly different from the other tools and I'll make it act more like the others.
fromsoysauce:
Ahh, ok, thanks for that. Works!
Hypure:
I had my auto-save to a removable drive, then one day was using anim8or with the drive out, it posted about a dozen errors. Now it won't auto-save anywhere I set the CONFIGURATION settings to. Any ideas?
Trevor:
Steve, Im not sure that refrence images should be exported in obj and stl.
Im not sure when they started to be exported but it means removing them before exporting which I forget since they are in a hidden layer.
Refrence images should be an8 only, If they are to be exported they should explicitly be converted to mesh.
I guess you could add a questionbox on exporting stating
"You have 1 or more reference images in this object.
Do you want to export these too?
YES NO"
Trev
Steve:
Hypure: I'll look into the auto-save problem.
Trevor: You're right, reference images aren't really a part of the model. They shouldn't be exported.
#098-078 - Auto-save to a removable drive problem.
#098-079 - Reference images shouldn't be exported in obj and stl.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version