General Category > Ongoing Anim8or Development

Mouse Wheel: zooms views, scrolls toolbars

<< < (3/4) > >>

Steve:
Good idea, bamman62.  How's this: General UI and Workflow Suggestions

bamman62:
Perfect. Thanks!

Raxx:
Bug report:

If you use the mouse wheel and immediately try to middle-click and zoom with the arc rotate tool, it fails to zoom. There seems to be a very short interval after the mouse wheel is used in which middle clicking is ignored. Sometimes when I middle-click-dragged to zoom, it wouldn't work--that was because sometimes when middle clicking, the mouse wheel moves a little, activating this bug.

I'm assuming (hoping) this isn't an issue with just my mouse.

[edit]I found another bug.

It seems that if you have a tool active (let's say we're using the select tool), and use the mouse wheel to zoom, then try to use the tool, it still does the mouse picking as if it wasn't zoomed. In other words, you have to select where the shape used to be in the workspace in order to select/move/rotate/etc it. This bug stops happening when a tool is changed, until you use the mouse wheel again.

Claude:
Minor thing,I noticed:
when the CAD ruler is on and the mouse wheel is used to zoom  in and out, the dimension lines are not updated.

Steve:
Raxx: did the middle-click + arc-rotate bug get better after I fixed the Alt-key lag problem?

Thanks for the bug reports:

#098-010 - Picking uses old viewport immediately after zooming with the mouse wheel.

#098-011 - When the CAD ruler is on and the mouse wheel is used to zoom in and out, the dimension lines are not updated.

Navigation

[0] Message Index

[#] Next page

[*] Previous page