General Category > General Anim8or Forum

Adjusting Z-near/fare relative to camera and scene size..... (rewrite)

<< < (2/2)

Water Music:
Two things would be nice for this:  1) being able to set the scale of the Anim8or units in object mode to cm/m/km or inches/feet/miles 2) being able to set the xyz scale of an object in scene mode. 

Hypure:
I like the idea of changing the measuring units, that would be very helpful...   On another note, back to what Kreator mentioned,  I have had a couple times where I wished I could export everything in a scene as a combined single object-just to play around with....

Hypure:
So apparently ruler isn't available in scene mode, or is there some other?....   What I'm trying to figure out is the "cad" measurements for the camera lens in scene mode..just as referenc..  In the picture below is a box that is 200 square at the end, a relative estimate with this is fine, no big deal.   Are these cad measurements standard with something?   I was wondering because am doing a project that I would like printed and noticed that cad has a measurment settings to adjust units...  If I have ALLOT to learn on this subject that is fine too.. ::) ;D

kreator:
I calculate in 4mm scale for my 00 scale locomotives so I set my grid as 4 instead of 10. the grid is then in 4mm scale which works for me. 8) 

Navigation

[0] Message Index

[*] Previous page