General Category > General Anim8or Forum

Problem extruding on a path

(1/1)

JSmith_DumDumDumDumDum:
Hello,

I'm trying to create a mesh by extruding Path_BooleanSubtractor along the path Path_tobeLathed. The final results is a flat curved plane (Result_thatIdon't_want), not a trapezoidal S-hook. It's the trap. S-hook that I want.

Unless I misunderstood, the instructions in the Anim8or manual stated that the starting point of the mesh needs to be at the orgin (0, 0, 0?). I think I did just that.

How do I fix this? Thanks.

Sluggs:
On the first path, you have to "Build/Join Splines" otherwise the final mesh will be messy. :o

PS. Your main path is faulty and you should make a fresh one.

Navigation

[0] Message Index