General Category > Anim8or v1.0 Discussion Forum

Copy past issue. World-object coordinates issue

<< < (7/8) > >>

nemyax:

--- Quote from: Gyperboloid on September 22, 2017, 12:54:39 pm ---the " Select Face Edges " command was removed, though it's still usable in Point Editor through its hotkey "t". Can you restore it ?

--- End quote ---
That's taken care of by the Extend Point Edge Face Selection option now.

Gyperboloid:
Hm, yes I thought about it. Then I should say that "t" shortcut should be removed from Point Editor instead, like the " l " shortcut too.

fefe01:
Help me guys! I can't find the setting for the object, figure, sequence, and scene mode. As a consequence, i can't rename them. I can't put the figure to the sequence mode. I can't also modify the environment and the scene setting. Was the path changed or is it a bug? ???

thecolclough:

--- Quote from: fefe01 on October 16, 2017, 07:29:01 am ---Was the path changed or is it a bug? ???
--- End quote ---
the menu path changed in the development builds leading up to v1.0, so the manual might now be out of date.  settings for each object are now accessed through Object > Properties, and so on for the other modes.  Scene > Properties gives you access to the Environment and Movie Image controls too :)

fefe01:
Thank you very much Thecolclough. It helped me a lot! :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page