General Category > Ongoing Anim8or Development
v1.01 Development Release - Build 1403, August 29, 2022
Steve:
Alpha2, I can't reproduce this. What camera controller's key is being set, "position"? I tried this:
1. Enable animation.
2. Set the camera's layer to 2.
2. Lock layer 2.
4. Switch to Camera view.
5. Scroll the mouse wheel in the camera view.
No new keys appear for the camera. If I unlock layer 2 then it sets a new key.
Alpha2:
hmmm my bad Maybe it wasn't the scroll wheel this time I could sworn that's what caused it. But I went back to test it and it did create a key frame when I moved the camera with arc rotate. Here's what I did:
1. Activated animation in scene mode.
2. set camera to layer 7.
3. right clicked the layer number in the top bar to lock it.
4. moved several frames into the animation.
5. turned on Arc Rotate
6. changed position and orientation which resulted in key frames
7. I moved to several other frames to make sure and each time both position and orientation changes with arc rotate created key frames.
(additionally, just to be thorough, I went in to the camera properties and ticked the lock check box and the arc rotate still keyed both position and orientation.)
Steve:
OK I can reproduce it now. I wasn't using Arc-Rotate but just scrolling the mouse wheel in the camera view. I'll fix it.
Alpha2:
Excellent.
...Okay so I've run into another bit of weird behavior, which I think I might be tied to why I was getting annoyed with the IK handles showing up in renders. I usually use scanline for simplicity, but today I had an image where the draw distance seemed to be cut off way too close (and I wasn't using fog,) so I was testing the other renderers to see if they extended the the draw distance in the image and after each image render I noticed the IK handle visibility kept getting toggled on when I returned to the scene mode. Every time I turned it off so it wouldn't show in the render, when I returned to the scene it was back on again.
Hope I'm not bugging you with all these.
Steve:
What tool were you using? If it is the IK tool then it automatically turns IK visibility and Animation on because those are usually what you want.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version