General Category > General Anim8or Forum

Malformed faces

<< < (2/3) > >>

FWL:
Hi Steve,

I've tried some modelling with the check structures on and the error ocurred again. I got a pop up warning for bad uv coordinates, when I used the flip edge tool in subdivision mode. So considering the previous occurences of this issue I've got the feeling it has something to do with the edgeflip tool. I've attached both the corrupted file and the repaired file. 

Steve:
Good information. I'll try to reproduce it. But can you post the .an8 file just before you do the flip edge as well? That will make it much easier to find. It might work to use the Undo tool when the error occurs.

FWL:
I'll see what I can do. Undo as I recall doesn't work. It undos the flip edge but not the face coordinate problem. When undo-ing and saving you still get the error at reopening. But I'll see if I can save after each editing step and create the pre fatal step history this way.

FWL:
Steve, I have a file just before the error pops up. When you flip the edge selected on the image attached then you'll get the error. I hope it's helpful.

Steve:
This should definitely, but, sorry, I can't see which edge is selected in the image.

Navigation

[0] Message Index

[#] Next page

[*] Previous page