General Category > General Anim8or Forum

Edge properties

(1/1)

Roygee:
The model I'm making needs to be mostly smoothed, but parts to stay hard and sharp - I normally use edge re-enforcement, by cutting through close to the edge and this works fine, but in this model that method would be way too complex and really messy.  I tried using edge properties, with a setting of creased, value 2, but when I convert to subdivided
(just a single subdivision), there is no difference - everything is rounded.

What sort of settings should I be using? ???

Kubajzz:
To set how the edge will look after subdivision you must use "rounded" value.
http://www.anim8or.com/manual/4_object_editor.html#edge_editing

Dasoccerguy:
i find that sometimes bevelling certain edges can give that effect, but it might be just as messy as reinforcing the edges...
hope you find your answer

hihosilver:
Dasoccerguy:  Beveling edges is a way of edge reinforcement.

Navigation

[0] Message Index