General Category > Ongoing Anim8or Development
Changed to Older Releases [builds 1162 to 1230]
captaindrewi:
+1 Shift + LMB = MMB :)
fromsoysauce:
Does extrude edges not work anymore if you have more than 1 edge selected?
Steve:
Extrude Edge should work with multiple selected edges. Make sure that the edges have only one face attached.
fromsoysauce:
That is strange. I just ran a test this moment: had a mesh cube, cut the bottom face, selected the open edges and tried to extrude it. It didn't work. it simply deselected the edges.
Sluggs:
--- Quote from: fromsoysauce on February 23, 2016, 09:40:14 am ---That is strange. I just ran a test this moment: had a mesh cube, cut the bottom face, selected the open edges and tried to extrude it. It didn't work. it simply deselected the edges.
--- End quote ---
It's working fine here. :-)
PS. Thanks for the Knife tool update, Steve. Works great!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version