General Category > Anim8or v0.98 Discussion Forum

[fixed] Modifier, Type related issues.

(1/3) > >>

MvGulik:
#098-043 - Multiple Modifier issues in properties dialog and copy/paste.
Fixed: v0.9.8 build 1127
Fixed(additionals): Build 1137
A couple of latent Modifier hiccups.

Tested against build 1121.

1 minor.
1 show-stopper.
1 possible hidden minor.

Modifier, Bend, Copy and paste: (v<=0.6.0.0)
- Create Modifier(Bend)
- (Bind a cylinder that's sticking out a bit at the top and bottom of the modifier)
- Set Bend to n>0. (90)
- Cut and Past the Modifier.
* (Cylinder at one of the modifier sides sticking way to far out.)
- Open Modifier Editor and close. (OK or Cancel)
* Modifier seems to collapses to height zero.

Modifier, Skew, Settings shift: (Appears between: v0.9.8.1 & v0.9.8.1088)
- Create modifier(Skew).
- Change modifier settings Skew(1) and Angle(45) + OK.
* Modifier is showing Skew 1, but not the Angle.
- Open Modifier Editor.
* Skew is now zero and Angle is now 1 (even if Angle was previous set to Zero).

Modifier, Skew, Copy and paste: (v<=0.6.0.0, up to 0.9.8.1)(Might still be there in 1121)
- Create modifier(Skew).
- Change modifier settings Skew(1) and Angle(45) + OK.
- Cut and Paste the modifier.
* Skew settings where copied, but are not used anymore by the paste modifier.

(Modifier resets to normal behavior after changing its Type.)
(Swell, Taper, Twist: Nothing out of the ordinary spotted.)

*forcing full topic fix*

Steve:
#098-043 - Multiple Modifier issues in properties dialog and copy/paste.

I have the settings shift part fixed for the next drop but am still chasing down the apparently long standing copy/paste issues. Thanks for the report!

Steve:

When I posted build 1127 I forgot to mention that bug #098-043 "Multiple Modifier issues in properties dialog and copy/paste" has been fixed, including the bend modifier sticking out to the right, etc. I also fixed several modifier related issues with Undo/Redo.

Give it a try and let me know if all your issues have been addressed.

MvGulik:
Roger, thanks.

Taking some time for this.

Just to make sure. The following behaviors are intentional features, correct?
- When you [move, rotate, scale] a modifier with the mouse. Only the modifier part is affected and not the bound item(if any).
- A modifier bound item can't be edited [move, rotate, scale]+(with mouse) while its bound to a modifier (only bound item selected).

(ps: The zipped build 1124 exe.file is named 1224.)
*spelling*

MvGulik:
Little leftover problem ...
- Create modifier. (Any I think, using Bend)
- Copy. (modifier still selected)
- Paste. (Crash ... oops)
Fixed: v0.9.8 build 1137

(Build 1124 is not having this problem)

*spelling*

+(Initial spotted issue at start of testing, so not sure yet if there are no other issues.)

Navigation

[0] Message Index

[#] Next page